ADS7924: Intelligent System Power Control

The ADS7924 is the industry's first ADC with Intelligent System Monitoring and Self System Monitoring capability. The ADS7924 works with any low power system that requires sensor monitoring, to potentially lower power across the board by over 50 percent.

Features

• Intelligent Monitoring:
• Auto-Sequencing of 4-Channel Multiplexer
• Individual Alarm Thresholds for Each Channel
• Programmable Scan Rate
• Micropower Monitoring:
• Four-Channel Scanning:
• Every 1ms → 25µW
• Every 10ms → 5µW
• < 1µA of Power-Down Current
• Programmable Interrupt Pin Controls Shutdown/Wakeup of the Microcontroller
• Auto Power-Down Control
• PWRCON Pin Allows Shutdown of External Op Amp
• Wide Supply Range:
• Analog Supply: 2.2V to 5.5V
• Digital Supply: 1.65V to 5.5V
• Small Footprint: 3mm × 3mm QFN
• APPLICATIONS
• Portable and Battery-Powered Systems:
• Medical, Communications, Remote Sensor Signal Monitoring, Power-Supply Monitoring
• Energy Harvesting

You could order the samples from TI under the following Link: Order a Sample

Kendu International Inc. - IC Testing Receptacle

IC Testing Receptacle
Feture:
1. Easy for socket replacement
2. Optimum DUT/Burn-In board life time
3. High reliability, ultra low contact resistance
4. Customer design available

TI: EZ SDK for Linux on C6A816X

The Linux EZ Software Development Kit (EZ SDK) allows customers to evaluate their devices in minutes and begin development in less than an hour. This kit provides everything Integra™ developers need to evaluate and start developing on the C6A816x DSP+ARM® processors.

Linx: USB Module

QS Series

USB Module

Do you want to simply add USB to your hardware and are worried to write drivers and adding new components? No worries. QS Series from Linx can do the job. 

The QS Series USB module allows the rapid addition of USB to virtually any device. Housed in a compact SMD package, the module provides a complete solution for converting between USB and CMOS / TTL logic level serial sources. The module can be directly connected to virtually any serial device including microprocessors, RS-232 / RS-485 level converters, or Linx RF modules. The QS Series module is completely self-contained, so it requires no external components, (except a USB jack) and includes all necessary firmware and drivers, freeing the designer from complicated programming. Power can be supplied externally or from the USB bus. Both USB 1.1 and USB 2.0 are supported at data rates up to 3Mbps.


/http://www.linxtechnologies.com/Products/Interface-Modules/QS-Series-USB-Module/